# Preparing a car after long storage

A clear guide to preparing a car after long storage: checking tire pressure, fluids, brakes, the battery and rodent damage before the first start.

Preparing a car after long storage means inspecting it fully before you turn the key, then bringing it back into use in stages. The work covers tires, fluid levels and oil, brakes, the battery and signs of rodent damage, all checked while the engine is still off. This page explains what to look at, in what order, and which jobs belong with a trained specialist. 

## Inspect before the first start 

Preparing a car after long storage begins with a full walkaround while the engine stays off. Look at the tires for flat spots, cracks or a loss of pressure, and check the tire pressure against the figure on the door pillar. Open the hood and look for nesting material, chewed wiring or droppings that point to rodent damage. Note every fault you find before you attempt a start, since a cold engine hides some of them. 

## Check fluids and oil level 

Fluid levels tell you how the car sat through storage and what needs attention first. Pull the oil dipstick and read the level, and look at the color of the oil rather than trusting the level alone. Check the coolant, brake fluid and washer fluid reservoirs against their marks. A low reservoir points to a leak that storage may have made worse, so trace it before you drive. 

## Reconnect the battery and start 

Reconnecting the battery is the last step, and it comes after the inspection and fluid checks are done. Clean the terminals, fit the cables in the right order and make sure the clamps are tight. Turn the key or press the start button and listen for unusual noises rather than revving the engine. If the car does not start, stop and find the cause instead of cranking it repeatedly. 

## Questions about reviving a stored car 

### What should I check first when preparing a car after long storage? 

The tires come first when preparing a car after long storage, because they carry the weight and show damage quickly. Check the pressure against the door pillar figure and look for flat spots or cracks in the sidewalls. Move on to the fluid levels and oil, then inspect the engine bay for rodent damage. Leave the battery connection and the first start until these checks are complete. 

### How do I check tire pressure after storage? 

Tire pressure after storage should be checked cold, before the car moves, using a gauge on each tire in turn. Compare each reading with the figure on the door pillar or in the manual, not with the number molded on the tire. Add air where a tire is low and look again for slow leaks over the following days. A tire that keeps losing pressure needs a professional inspection. 

### Do I need a brake inspection after storage? 

Yes, a brake inspection after storage belongs on the list, because rotors can rust and calipers can seize while a car sits. Look at the rotors through the wheel spokes for heavy rust and check the brake fluid level. Press the pedal before you drive and note whether it feels firm or soft. A soft pedal or a scraping noise means a trained mechanic should examine the brakes. 

### How do I reconnect the battery and make the first start? 

Reconnect the battery only after the inspection and fluid checks are finished, with the ignition off. Fit the positive cable first, then the negative, and make sure both clamps are tight and the terminals are clean. Start the engine and let it idle while you listen for odd noises and watch the warning lights. If a light stays on or the engine sounds wrong, switch off and find the cause.
