How to change an oil filter at home
Learn how to change an oil filter at home: find the filter, drain the oil safely, remove and refit the filter with the right gasket and torque, and check for leaks.
Contents
Changing an oil filter at home follows a clear order: locate the filter, drain the old oil into a pan, unscrew the filter, fit the new one with a fresh gasket, and check for leaks afterward. The job needs a drain pan, an oil filter wrench, the correct replacement filter and the oil grade your engine calls for. Work on a cold or warm engine, never a hot one, and dispose of used oil at a proper collection point.
Find the filter and prepare
Oil filter location decides how much room you have to work, so find it before you start. The filter sits on the engine block, often reachable from below or through the top of the engine bay. Park on level ground, let the engine cool, and set the parking brake before you raise the vehicle. A drain pan placed under the drain plug keeps the used oil contained.
Remove the old filter
Oil filter removal starts with draining the sump, because the filter still holds oil when the engine stops. Loosen the drain plug and let the oil run into the pan until the flow slows to a drip. Turn the old filter counterclockwise by hand first, and use an oil filter wrench only when it will not budge. Old filters can be tight, so keep the wrench square on the canister to avoid crushing it.
Fit the new filter correctly
A new gasket comes with the replacement filter, and that gasket is what seals the joint. Wipe the mating surface clean, coat the gasket with a little fresh oil, and turn the filter on by hand until it contacts the surface. Oil filter torque matters here: follow the figure printed on the filter or in the service manual, and stop once it is reached. Over-tightening distorts the gasket and makes the next removal harder.
Oil filter change questions
How do I change an engine oil filter at home?
Changing an engine oil filter at home means draining the oil first, then unscrewing the old filter and fitting a new one. You need a drain pan, an oil filter wrench, the correct filter and the right oil grade. Refill the engine, run it briefly and check the filter and drain plug for leaks. Take the used oil and filter to a collection point that accepts them.
How do I change an oil filter at home safely?
Changing an oil filter at home is safe when you avoid working under a vehicle held only by a jack. Use rated stands on level ground and let the engine cool before you touch hot parts. Used oil irritates skin, so wear gloves and keep it away from your eyes. If you cannot reach the filter or the drain plug safely, hand the work to a trained technician.
What tools do I need for oil filter replacement steps?
The oil filter replacement steps call for a drain pan, an oil filter wrench, a socket or wrench for the drain plug, and a funnel for refilling. You also need the new filter, its gasket, fresh oil of the specified grade and a torque wrench if the filter or plug has a stated figure. Gloves and rags keep the job clean. A vehicle raised on stands should never be worked under without them.
How tight should an oil filter be?
An oil filter should be tight enough to seal but not so tight that it deforms the gasket. Turn it by hand until the gasket touches the mating surface, then follow the torque printed on the filter or given in the service manual. If no figure is available, ask the parts supplier for the specification. Tightening past that point makes removal difficult next time.