# Drive belt replacement procedure

A plain guide to the drive belt replacement procedure, covering serpentine belt routing, tensioners, pulley alignment and the checks to make before and after fitting.

The drive belt replacement procedure covers removing the worn serpentine belt, checking the pulleys and tensioner, and fitting a new accessory drive belt along the route set by the engine maker. This page explains each stage of the car drive belt replacement and the car serpentine belt replacement in order, so you can judge what the job involves and what to check before the engine runs again. 

## Reading the belt routing before removal 

A belt routing diagram shows how the new belt wraps around each pulley, including the smooth and grooved sides. The diagram is printed on a sticker under the hood or in the service information for the engine. Photograph the old belt in place before you take it off, because the new belt must follow the same path. A wrong route can leave one accessory un driven or twist the belt against a pulley. 

## Releasing tension and taking off the old belt 

The belt tensioner holds the serpentine belt tight against the pulleys and must be released before the belt comes off. A wrench or breaker bar fits the tensioner arm, and turning it moves the pulley away from the belt. With the tension released, slide the belt off a single pulley and then unwind it from the rest. Store the old belt flat so you can compare its length and profile with the replacement. 

## Checking pulleys, alignment and the new belt 

Belt inspection by eye looks for cracks across the ribs, frayed edges, glazing and missing chunks on the old belt. Spin each pulley by hand and listen for rough bearings, and check that every pulley lines up with its neighbors. Pulley alignment matters because a pulley that sits out of line wears the belt edge and can throw it off. Fit the new belt by hand along the routing diagram, release the tensioner back into place and confirm the belt sits centered on every pulley. 

## Questions about drive belt replacement 

### Do I need a special tool to release the belt tensioner? 

A special tool is not always needed for a belt tensioner, because many tensioners have a square hole or a cast lug that takes a breaker bar or a socket. The space around the tensioner decides which tool reaches the arm, and some engines need a long handle to move it. Check the service information for the engine before you start. 

### Can I drive with a cracked serpentine belt? 

No, a serpentine belt with deep cracks or missing ribs should be replaced before the car is driven, because the belt can fail and stop the accessories. A failed belt can also leave the battery uncharged and the engine overheated. Belt inspection by eye on a cold engine shows cracks, glazing and frayed edges. Have a trained technician check the belt if you are unsure how worn it is. 

### How do I know the new belt is on the right way? 

The new belt is on the right way when it follows the belt routing diagram exactly and sits centered on each pulley. Grooved pulleys take the ribbed side of the belt, and smooth pulleys take the back of the belt. Turn the engine by hand once the belt is fitted and watch that the belt stays in place along the whole route. 

### What causes a new belt to come off a pulley? 

A new belt comes off a pulley when a pulley is out of line, a tensioner is weak or the belt follows the wrong route. Pulley alignment problems show as a belt that walks toward the edge of one pulley. A trained technician can measure alignment and check the tensioner before another belt is fitted.
