# Clipboard and supplies for viewing a car

What to bring to a car viewing: a clipboard with a printed checklist, pen, flashlight, magnet, tire tread gauge, tape measure, OBD scanner and the documents you need.

A clipboard for car viewing holds a printed checklist, a pen and a notepad so you can write down what you see at each listing. Bring a flashlight, a magnet, a tire tread gauge, a tape measure and an OBD scanner to check the car rather than trust a description. Pack the documents you need before you leave, because a viewing is your only chance to record the details. 

- A clipboard with a printed checklist keeps every car you view recorded in the same order.
- A flashlight and a magnet reveal bodywork and fluid problems that daylight hides.
- A tire tread gauge and tape measure give you numbers instead of guesses.
- An OBD scanner reads stored fault codes before you agree to anything.
- Bring the seller's paperwork and your own ID so the viewing is not wasted.
 

## Why a clipboard belongs in the car viewing kit 

A clipboard turns a car viewing into a set of written answers instead of a memory test. The board holds a checklist, a pen and a notepad, and you fill each line while you stand beside the car. Notes written on the spot stay accurate when you compare several listings later. 

The checklist should follow the order of the inspection, from the outside of the car to the engine bay and the cabin. A fixed order means you check the same points on every car and spot differences between listings. Leave space beside each line for a short note and a rating you define yourself. 

Keep the finished sheets in a folder, one per car, with the listing reference written at the top. Writing the asking details and the seller's answers on the sheet keeps each record complete. A clipboard and notepad cost little and save you from mixing up two similar cars. 

## Documents to bring to a viewing 

Documents to bring to a viewing depend on what the seller must show you and what you must show the seller. Ask before the appointment which paperwork the owner holds for the car. Carry your own identification and proof of insurance in case a test drive is offered. 

For the car, look for the registration or title document, the service record and any repair invoices. The [vehicle identification number](/articles/vin-serial-number-and-registration-number-how-they-differ-when-comparing-car-listings/) on the car should match the number on the paperwork. Note the registered owner's name and check it against the person you meet. 

Bring a printed copy of the listing and your checklist so you can compare claims with the car. A small folder keeps papers dry and in order. Never hand over original documents to a seller who asks to keep them. 

- Your identification and driving license
- Proof of insurance for a test drive
- Printed copy of the listing
- Blank checklist sheets and a pen
- Service record and repair invoices from the seller
- Registration or title document to inspect
 

## Lighting and measuring tools for bodywork 

A flashlight and tape measure cover the checks that daylight and a quick glance miss. A strong handheld light shows paint mismatch, scratches and dirt in panel gaps. A tape measure confirms the width and depth of a repair area you suspect. 

Shine the light along each panel at a low angle to reveal ripples from filler or a repaint. Look inside the wheel arches and under the sills where rust starts. Check the trunk floor and the area under the carpets for damp or fresh sealant. 

A small magnet tells you whether a panel is steel or plastic filler. The magnet clings to steel and slides over a filled area with a weaker pull. Test the same panel on both sides of the car so you have a comparison. 

## Checking tires, glass and trim 

A tire tread gauge gives you a tread depth figure that you can compare across the four tires. Uneven depth between tires points to alignment or suspension work. Write the depth for each tire on the checklist instead of describing the tires as worn. 

Inspect the sidewalls for cracks, bulges and repair plugs, and check the date code molded into each tire. Tires of different ages or brands suggest the car was maintained to a budget. Glass chips and trim clips are cheap to check and easy to miss in poor light. 

Open and close every door, the trunk and the hood, and listen for a consistent sound. Uneven gaps or a door that needs a hard push can follow a collision repair. Record what you find next to the panel it affects. 

## Electronic checks with an OBD scanner 

An OBD scanner reads the fault codes stored by the car's onboard diagnostics system. The connector sits under the dashboard on the driver's side in many cars. Switch the ignition on without starting the engine and let the scanner connect. 

Read the stored codes and the readiness monitors before you clear anything. A seller who has just cleared the codes hides the history, and the monitors will show that the system is not ready. Write the codes down exactly as the scanner displays them. 

A basic scanner shows codes but not live data, while a more capable model shows sensor readings as the engine runs. Choose the scanner by the depth of check you can perform and by the connector the car uses. A trained mechanic is needed to interpret codes that point to engine or transmission faults. 

## Test drive kit and what to record 

A test drive kit is small: the clipboard, a pen, your documents and a phone for photos. Ask the seller to let you start the engine from cold so you can hear the first seconds. Record the mileage at the start and the end of the drive. 

Listen for noises over uneven road, and note whether the car tracks straight with your hands light on the wheel. Test the brakes at low speed in a safe place before joining faster traffic. Check that every warning light goes out after the engine starts. 

Write down how the gearbox shifts, how the steering feels and whether the air conditioning cools. Stop somewhere safe and repeat a few checks from the inspection with the engine warm. A seller who refuses a test drive gives you a reason to walk away. 

## Building a shortlist from your notes 

Comparing listings side by side starts with the same checklist for every car. Sort the sheets by the points that matter to you, such as body condition, service history and fault codes. A car that scores well on paper still needs the notes to back it up. 

Mark each sheet with a simple verdict: keep, question or drop. Add a short reason for each verdict so the sheet explains itself later. Two cars with the same score can still differ in the risk their notes reveal. 

The shortlist you build should name the questions you still need to ask each seller. A clear record of what you saw protects you from a rushed decision. Keep the folder until you have chosen a car and collected its paperwork. 

## Questions about car viewing supplies 

### What should I bring to a car viewing? 

Bring a clipboard with a printed checklist, a pen and a notepad, plus a flashlight, a magnet, a tire tread gauge, a tape measure and an OBD scanner. Add your identification, proof of insurance and a printed copy of the listing. The car viewing kit fits in a small bag and covers the checks that matter. 

### Is a clipboard really useful for a car viewing? 

Yes, a clipboard keeps the checklist and the pen in your hands while you inspect the car. Notes written during the viewing stay accurate and let you compare several listings side by side. A plain folder with loose sheets works too, but the board makes writing easier. 

### Do I need an OBD scanner at every viewing? 

An OBD scanner is worth carrying if you can read the codes it shows without guessing. It reveals stored faults and whether the seller has recently cleared the system. Codes pointing to engine or transmission problems need a trained mechanic to interpret. 

### Which documents should the seller show me? 

Ask the seller to show the registration or title document, the service record and repair invoices. Check that the vehicle identification number on the car matches the paperwork. Note the registered owner's name and compare it with the person you meet. 

### How do I compare notes from several car viewings? 

Use one checklist per car in the same order, then sort the sheets by the points you care about. Mark each sheet keep, question or drop with a short reason. The folder of sheets becomes the shortlist you can explain to yourself later.
