# Bicycle gear ratio comparison

Learn how to compare bicycle gear ratios from chainring and cassette teeth, convert them to gear inches or development, and check cadence against speed.

A bicycle gear ratio comparison puts the gearing of two setups on the same footing so you can see which is harder to push and which spins easier. You take the teeth count of the chainring and divide it by the teeth count of the rear sprocket, then express the result as gear inches or development so wheels of different sizes can be judged fairly. The page explains each figure, shows how to run the comparison by hand or with a calculator, and lists the details to record side by side. 

## Reading chainring and cassette teeth 

Every gearing comparison starts with the tooth counts stamped on the chainring and on each rear sprocket. Dividing chainring teeth by sprocket teeth gives the ratio for that gear, so a larger chainring or a smaller sprocket raises the number. Record the full cassette, not one cog, because the spread between the easiest and hardest gear matters as much as any single value. A ratio on its own says nothing about wheel size, which is why the next step converts it. 

## Gear inches and development explained 

Gear inches and development translate a ratio into distance so that bicycles with different wheel sizes can be compared. Gear inches multiply the ratio by wheel diameter, while development multiplies the ratio by wheel circumference to give the distance covered in one crank turn. Both figures depend on tire size as well as rim size, so measure the wheel as it sits on the bike. Comparing two listings means matching the same measure on each side, never gear inches on one and development on the other. 

## Cadence, speed and the gear you need 

Cadence and speed together show what a given ratio delivers on the road. Speed rises with cadence and with the gear number, so a comparison table should pair each gear with the speed it produces at a chosen pedaling rate. Riders who prefer to spin keep a lower ratio for climbing, while those who push a bigger gear accept slower cadence on the same slope. Build the shortlist around the terrain and cadence you actually ride, and note the tooth counts beside every figure. 

## Questions About Bicycle Gearing Comparison 

### How do I compare gear ratios between two bikes? 

Comparing gear ratios between two bikes means converting each drivetrain to the same measure before you judge it. List the chainring and cassette teeth for both, calculate the ratio per gear, then convert to gear inches or development using each bike's actual wheel size. Place the results side by side so the easiest and hardest gears line up for a direct read. 

### What does a gear ratio comparison calculator for a bicycle need? 

A gear ratio comparison calculator needs the chainring tooth counts, the cassette tooth counts and the wheel diameter or circumference you measured. Enter those values and it returns the ratio per gear plus gear inches or development for each combination. Check that the calculator uses the same wheel figure for both setups, or the comparison will mislead you. 

### Is a higher gear ratio always faster? 

A higher gear ratio is not always faster, because speed also depends on how fast you can turn the cranks. A tall gear covers more ground per turn but demands more effort, so on a climb it can slow you down. Match the ratio to the cadence you can hold on the ground you ride. 

### What is the difference between gear ratio and gear inches? 

Gear ratio is a plain number from dividing chainring teeth by sprocket teeth, and gear inches add wheel size to that number. The ratio alone cannot compare a small wheel with a large one, while gear inches can. Development goes further and gives the distance traveled in one crank revolution.
