# AHP consistency ratio: formula, index and interpretation

How the AHP consistency ratio is built from the consistency index and random index, how to read the values, and what the 0.1 cutoff means.

The AHP consistency ratio is a check on how far a pairwise comparison matrix departs from perfect logical agreement. It compares the consistency index of your matrix with the random index for a matrix of that size, and a ratio above the 0.1 threshold signals judgments worth revisiting. The page explains the formula, the index it draws on, and how to interpret the result. 

## The consistency index and its formula 

The consistency index in AHP measures the divergence between the principal eigenvalue of a pairwise comparison matrix and the matrix size. You compute it as the maximum eigenvalue minus the number of criteria, divided by the number of criteria minus one. A perfectly consistent matrix has a maximum eigenvalue equal to the matrix size, so its consistency index is zero. Larger values indicate greater judgment inconsistency across the pairwise comparison matrix. 

## The random index and how the ratio forms 

The random consistency index, often shortened to random index, is the average consistency index of randomly filled matrices of the same order. Saaty generated these reference values, and you read the appropriate one from a consistency ratio table by matrix size. The consistency ratio divides the consistency index by that random index. Because the random index grows with matrix size, the ratio keeps the measure comparable across different matrix orders. 

## Reading the ratio and the 0.1 threshold 

The consistency ratio threshold of 0.1 is the reference point for interpretation of the ratio. A value at or below 0.1 is treated as acceptable judgment inconsistency, while a value above it points to contradictions in the pairwise judgments. If the ratio exceeds the threshold, revisit the comparisons that seem out of line and revise them. Changing entries can move the maximum eigenvalue, so recompute both the consistency index and the ratio afterward. 

## Questions about the AHP consistency ratio 

### What does consistency ratio in AHP mean? 

The consistency ratio in AHP expresses how much inconsistency your pairwise comparison matrix contains relative to a random baseline. It is the consistency index divided by the random index for the same matrix size. A low ratio means your judgments mostly agree with each other, and a high ratio means they conflict. The ratio is a diagnostic of judgment inconsistency, not a measure of whether the priorities are correct. 

### Is there a formula for the consistency ratio AHP calculation? 

Yes, the consistency ratio AHP formula is the consistency index divided by the random index. The index itself is the maximum eigenvalue minus the matrix order, divided by the order minus one. You find the random index in a reference table matching the matrix order. Both steps use the same pairwise comparison matrix, so any revised judgment requires a fresh calculation. 

### Is there a consistency ratio table I can use? 

Yes, a consistency ratio table lists random index values against matrix sizes, which lets you complete the ratio without recomputing the random baseline. You look up the random index for the order of your matrix and divide the consistency index by it. The table holds a single random index per matrix size. Larger matrices carry larger random indexes, and that is how the table keeps the ratio comparable. 

### How does an AHP consistency ratio calculator work? 

An AHP consistency ratio calculator takes the entries of a pairwise comparison matrix and returns the maximum eigenvalue, the consistency index and the ratio. It derives the maximum eigenvalue from the matrix, then uses a built-in random index for that matrix order. The calculator speeds up the arithmetic, but the judgments you enter still determine the result. Check any calculator against a hand calculation before relying on it.
