Acceleration figures test conditions and the 0-60 mph test method

Learn how 0-60 mph times are measured, which test conditions change the result, and how to compare acceleration figures across listings fairly.

3 min read3 viewsAcceleration figures test conditions and the 0-60 mph test method
— · 0 votes
Contents
  1. How the 0-60 mph test works
  2. Test conditions that change the result
  3. Comparing 0-60 times between listings fairly
  4. Questions about 0-60 mph acceleration tests
  5. What is launch control and does it change 0-60 times?
  6. Is an automatic faster than a manual from 0 to 60 mph?
  7. Why do 0-60 times differ between the maker and reviewers?
  8. Does a two-way average make a 0-60 time more accurate?

Acceleration figures depend on test conditions and the 0-60 mph test method used to record them. Road surface, weather, timing method and launch technique can each shift a published time noticeably. This page explains how the test works and which details to check before comparing two listings.

How the 0-60 mph test works

A 0-60 mph acceleration test times a car from a standstill until it reaches sixty miles per hour. Testers record speed with a satellite-based data logger, which is far more precise than a handheld stopwatch. Some testers start the clock only after a short initial roll, called rollout, which shortens the figure. Timing should use true road speed, since a car's speedometer may read higher than the actual speed.

Test conditions that change the result

Acceleration figures shift with test conditions such as road surface, weather, altitude and the load in the car. A dry, grippy surface lets the tires put power down without spinning at launch. Hot, thin air at altitude gives an engine less oxygen, which slows cars without a turbocharger in particular. Electric cars can also lose pace when the battery is cold or low on charge.

Comparing 0-60 times between listings fairly

Two 0-60 mph times can be compared fairly only when the test method and conditions match. Note whether each figure comes from the maker or an independent test, and whether rollout was used. Record the gearbox type and any launch control setting beside the time in your shortlist. Small gaps between figures from different sources may reflect the test rather than the car.

Questions about 0-60 mph acceleration tests

What is launch control and does it change 0-60 times?

Yes, launch control can lower a 0-60 mph time by managing engine speed and wheelspin at the start. Launch control is an electronic system that holds engine speed steady until the driver releases the brake. Repeated launches add strain to the drivetrain, so the owner's manual should guide its use. Acceleration tests belong on a closed track, away from public roads and other traffic.

Is an automatic faster than a manual from 0 to 60 mph?

Yes, in many modern cars an automatic gearbox shifts faster than a driver can work a manual. A dual-clutch gearbox, which preselects the next gear on a second clutch, cuts shift time further. Manual results also vary with driver skill, which makes repeat runs less consistent. Compare figures for the exact gearbox you plan to buy, since versions of one model can differ.

Why do 0-60 times differ between the maker and reviewers?

Published 0-60 mph times differ between sources because each one uses its own method and conditions. A maker may time a prepared car on an ideal surface in cool, dry weather. Reviewers often test whatever car and conditions they get, with or without rollout. Neither figure is wrong, but they only compare cleanly against figures from the same source.

Does a two-way average make a 0-60 time more accurate?

Yes, a two-way average makes a 0-60 time more reliable by reducing the effect of wind and slope. Testers make a run in each direction on the same stretch of road and average the two times. A single run with a tailwind or a slight downhill can look quicker than the car really is. Listings that state a two-way average give you a firmer basis for comparison.

Latest articles